Oct 18, 2023
Planning
- 1080p Project Planning Guide - Plan a 2G Omega video system
- 4K30 Project Planning Guide - Plan a 3G Ultra video system
- 4K60 Project Planning Guide - Plan a MaxColor video system
Wiring
- Dedicated Cat5e or better cable from the switch location to each Just Add Power Receiver
- Dedicated Cat5e or better cable from the switch location to each Just Add Power Transmitter
- HDMI cable to connect each Transmitter to source, and each Receiver to display
Hardware
- One Just Add Power Receiver per display
- One Just Add Power Transmitter per source
- Managed gigabit Ethernet switch with enough ports for each Just Add Power device plus one port for control access - Supported Switches
- Control system
Configuration
- Run AMP to configure the switch and all Just Add Power devices
Set Static Route - [2 Options]
- Log into the router and apply the appropriate Static Route. Routing information can be found in the AMP Report file.
- Set the Default Gateway of the control system processor to the IP Address of the managed gigabit Ethernet switch
Program Control System