Overview

The IR Dongle V2 - Flux Capacitor V2 - adds IR support to the Just Add Power 3G product line by converting the serial port into an IR blaster. Pronto, Global Cache, and Global Cache Compressed IR code formats are supported.

• Baudrate is 115200-8n1
• RS232 Feedback
• LED indicator
• LED responds on successful command
• Support for commands formatted as:
  • Pronto
  • Global Cache
  • Global Cache Compressed

If the IR Dongle does not have 'V2' printed on it, please see the article for IR Dongle V1

---

Included Wiring

The IR Dongle V2 ships with 4 cables:

1. IR Emitter (3V, 0.1A)
2. 3.5mm-to-3.5mm stereo plug
3. USB Type A to Micro USB cable
4. Y-shaped USB power tap

---

Requirements

3G devices must be on justOS firmware B1.2.1 or later

2G devices must be on firmware A6.5.9-LTS or later

---

Null Modem Jumper Position

The RS232 port on the Just Add Power device has a null modem jumper on the bottom that determines the transmit/receive pin position of the RS232 port.

Please see the [3G] Null Modem Jumper Pinouts article for the correct position. The Flux Capacitor always uses the Crossover position.

---

 

Setup

Setup 3G

1. Enable Layer 3 access to Just Add Power devices
2. Set the Null Modem Jumper in the crossover position. The positioning varies by device.
3. In the web interface, select Endpoint Control and set the Serial Mode to Flux IR Dongle (v2)
4. Reboot the unit

---

Setup 2G

1. Enable Layer 3 access to Just Add Power devices
2. Set the Null Modem Jumper in the crossover position. The positioning varies by device.
3. Telnet to the Receiver and send the command flux.sh v2
   • Alternatively, to set all Receivers to use Flux IR Dongle V2 with a single command, send commandallrx.sh "flux.sh v2"
4. Reboot the unit

---

Programming

Please see documentation for the Control System being used.

IR Dongle V2 supports Pronto, Global Cache, and Global Cache Compressed formats

Telnet to the IP address of the device at port 4998 and send the IR commands followed by a carriage-return (\r below)
sendir,1:1,1,38000,1,1,127,63,16,16,16,48,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,16,48,16,16,16,1000\r

---

Feedback

When a command is sent, feedback is provided by the IRDv2. Feedback responses are:

Executed Command	Feedback
Any Pronto IR code	ERR_001 (This is temporary as we adjust IR responses)
Any Global Cache IR code	completeir,1:1,1
getdevices	device,0,0 ETHERNET device,1,1 IR endlistdevices
getversion	version,1,FluxCapacitor_v2
get_NET	NET,0:1,[configlock],[ipsetting],[ipaddress],[subnet],[gateway]
get_IR	IR,1:1,IR
Any incorrect Global Cache code	ERR_001