Image Pop is the ability of any model of Just Add Power 2GΩ or 3G Receiver to display the uploaded Image Push Background as a graphic over the top of the video.

Image Pop will use the top-left-most pixel of the Image Push Background as the transparency color and remove all pixels are that color. The remaining colors are part of the logo that will be displayed on the video.

There are two locations that the Image Pop graphic can be displayed: top-left corner or center-screen.

Image Pop is a Receiver-only function. Commands to control Image Pop should be sent to the desired Receiver:

• image_pop on
• Enable Image Pop and place the image in the center of the screen
• Image Pop will remain on until the image_pop off command is sent
• image_pop on tl
• Enable Image Pop and place the image in the top-left corner of the screen
• Image Pop will remain on until the image_pop off command is sent
• image_pop off
• Disable Image Pop

There are two ways to change the Image Push Background on a Receiver:

1. Run JADConfig. Image Push Background image is applied during the firmware update step.
2. Follow instructions in the Image Push Knowledge Base article to upload an Image Push Background to a single device.