• Overview
• Compatible Models
• Download Configuration Files
• Modify Configuration Files

Overview

Follow the instructions below to configure a Pakedge switch for use with Just Add Power Multicast Switching.

Configure Just Add Power devices with AMP software.

Just Add Power devices support Multicast Switching on firmware B2.1.0 and later.

Compatible Models

• MS-2424P
• MS-4424P

Download Configuration Files

Load a pre-built switch configuration file to get up and going quickly!

Configuration files use these defaults:

• Username: pakedge
• Password: pakedge
• VLAN 1 IP (data): 192.168.1.205 /24
• VLAN 2 IP (JP Video): 172.17.255.254 /16
• Default Gateway (Router): 192.168.1.1

Note: The MS Series of switches by default are at DHCP - they get an IP address from the router - but for routing to work properly, we MUST assign a static IP to the switch.

Switch Config Files

Modify Configuration Files

1. Start with the pre-built Primary switch configuration file.
2. Change the Default Gateway to the IP address of the router at the jobsite.
3. Change the VLAN 1 IP to match the subnet that the router and control system at the jobsite are on

Full instructions on exactly how to make these modifications are included with the download.