Overview
This driver provides Matrix Control - switch any display to watch any source - in a Just Add Power VLAN switching system configured with AMP.
This driver works with a standard Crestron system. For the Crestron Home driver, go here.
Driver supports up to 101 inputs and 3000 outputs.
For Endpoint Control or Feature Control, create a generic telnet driver, set the IP address to the Receiver or Transmitter you want to control, and follow the directions for the desired control feature.
Contracted by Just Add Power.
This driver is NOT COMPATIBLE with systems configured with JADConfig.
Compatibility
The Crestron AMP VLAN driver is compatible with:
- All 3-series processors
- All 4-series processors
Download
Download Crestron Standardized AMP Driver
Versions
- JPSW driver 1.1.0
- JPSW_AVSwitch_1.1.0.umc
- JPSW_AVSwitch_1.1.0.ush
- JPSW_AVSwitch_1.1.0.usp
- JustAddPower_JPSW_Favourite_Switching_1.1.0.ush
- JustAddPower_JPSW_Favourite_Switching_1.1.0.usp
- libJustAddPower_JPSW_1.1.0.clz
- ITOA.ush
- ITOA.usp
- Demo profile v1.1.0
- JustAddPower_JPSW_Demo_1.1.0.smw
- JustAddPower_JPSW_1.1.0.vtp
- JustAddPower_JPSW_DemoProgramLogicOnly_1.1.0.ush
- JustAddPower_JPSW_DemoProgramLogicOnly_1.1.0.usp
Changes
- Adds a fallback controller IP. Enter a second Just Add Power device IP, in case the first device goes offline.
Other Drivers
For the Crestron Home driver, go to Crestron Home AMP VLAN Driver Download.
For drivers compatible with JADConfig, go to Crestron JADConfig Driver Download
