Overview
There are many ways to identify the model/SKU number of a Just Add Power transmitter or receiver.
These instructions will cover two ways to find this information:
- Command Line Interface [CLI]
- Physical Identification
Command Line Interface [CLI]
This function is only supported on Firmware A6.4.12 and later.
In certain cases, it's not always possible to reach a device physically in order to identify if its a transmitter or receiver. If this is the case, you can send the following command to any Just Add Power 2G device over Putty or Telnet:
getmodel.sh
Disclaimer: Due to how 2G models were manufactured, the command will only provide a model number.
Physical Identification
The print on top of every Just Add Power device identifies its model, but lacks the sku number that it represents. This section will provide you images of the model, and its associated SKU number for easy identification.
2G Receivers
Device Image | Device Model Number | Device SKU Number |
---|---|---|
2G RX | VBS-HDIP-208A | |
2GPOE RX | VBS-HDIP-208POE | |
2G+ RX | VBS-HDIP-218A | |
2G+POE RX | VBS-HDIP-218POE | |
2G+AVP RX | VBS-HDIP-218+AVP |
2G Transmitters (Standalone)
Device Image | Device Model Number | Device SKU Number |
---|---|---|
2G TX | VBS-HDIP-408A | |
2GPOE TX | VBS-HDIP-408POE | |
2G+ TX | VBS-HDIP-418A | |
2G+POE TX | VBS-HDIP-418POE | |
2G+AVP TX | VBS-HDIP-418+AVP | |
2G+SDI TX | VBS-HDIP-428A | |
2G+SDI POE TX | VBS-HDIP-428POE |
2G Transmitters (Rackmount)
Device Image | Device Model Number | Device SKU Number |
---|---|---|
2G Rackmount TX | VBS-HDIP-439A | |
2G+ Rackmount TX | VBS-HDIP-449A | |
2G+4+ Tiling Transmitter | VBS-HDIP-459A |