Overview

Every Just Add Power 2G, Omega, Ultra, and MaxColor has a 3-pin molex port on it that acts as a debug port for device recovery.

Debug Port Location

On earlier 2G devices, the port is inside the case on the top part of the board

On later Omega, Ultra, and MaxColor Series, the port is on the bottom of the case and accessible without removing any parts.

Pinout

The pinout is a standard RS232 wiring of Transmit-Receive-Ground.

The most common connector uses a Molex PHR-3 connector on one end and a DB9 connector on the other end.

Acquire a Cable

You can make your own cable using the instructions and images above, or you can request a cable from our support team.