CEC control in URC is best accessed by allowing the Accelerate process to build a user interface automatically. In order to do that through the Just Add Power system, a CEC driver must be converted to a CEC over IP driver. This change allows the URC processor to send CEC commands to a Just Add Power device over the network.
All functions on all manufacturers and models use the same CEC commands. The driver can be used without modification. The most important factor to functionality is whether the display manufacturer decided to support the function or not.
Disclaimer: Only the Power On, Power Off, and Input 1 commands have been tested. All other commands will see varying levels of success.
Download
Download contains Endpoint Control drivers for CEC, RS232, and IR.
Setup the Driver
Once the driver has been added to the local database, the driver must be setup through Accelerator. Follow these instructions:
In Program --> Step 4 Add Other Devices
Select Database: My
Select Module Type: IP Database
Select Category: TV
Select Brand: JUST ADD POWER
Select Model: CEC TV
Select Add Selected Module
In Program --> Step 6 Network Setup
Select Non URC Device
For each CEC driver, enter the IP address of the Receiver. The IP address can be found on the Report File generated by the configuration software upon initial configuration.
In Program --> Step 8 AV Inputs & Outputs
Select the CEC TV driver
Connect the HDMI output that the Just Add Power Receiver is in and connect it to the Output on the Just Add Power switching driver that matches its position in the matrix. The Report File contains this information.
Accelerate in Step 10 Edit User Interfaces and Step 12 Macro Editing to generate the interface. Done!