Articles containing tag Add a Device - Just Add Power Support

Support will close at 3:00 pm Eastern on December 20th. Limited support will be available from 8:00 am to 6:00 pm on December 23rd, 26th, 27th, and 30th. Support will be closed December 24th, 25th, and 31st as well as New Year's Day.

Happy Holidays!

Showing articles from Add a Device tag

[AMP] [Standardized] [Video] Add a Device to a System while Off-Site

Overview AMP - Advanced Matrix Programmer - is a software that configures 3G and MaxColor Just Add Power devices into an HDMI matrix switching system. This video demonstrates configuring a device to be added to a Standardized Configuration while Off-Site. Add Device expects that the switch already has an open port…

AMP Videos

24-Jun-2024

Standardized Let's Go Standardized Configuration Off-Site Expand Add a Device Video Training Advanced Matrix Programmer AMP VLAN

[AMP] [Standardized] [Video] Add a Device to a System while On-Site

Overview AMP - Advanced Matrix Programmer - is a software that configures 3G and MaxColor Just Add Power devices into an HDMI matrix switching system. This video demonstrates adding a device to a Standardized Configuration while On-Site. Add Device expects that the switch already has an open port previously config…

AMP Videos

24-Jun-2024

Standardized Let's Go Standardized Configuration Walkthrough On-Site Expand Add a Device Video Training Advanced Matrix Programmer AMP VLAN

Adding a Device to a Configured System

* Overview * Method 1: Setup a New System * Method 2: Configure a Device Overview When a Just Add Power system is configured - most often with JADConfig - ports on the managed Ethernet switch are setup to be connected to either a Transmitter or a Receiver. Just Add Power often recommends that the switch should…

JADConfig Documentation

22-Nov-2019

JADConfig Add a Device System Setup Expand