⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
How to Change Device Network Prefix using AMP Build New for Standardized Systems
Overview Just Add Power’s Advanced Matrix Programmer (AMP) enforces a standardized IP addressing scheme for all Devices to ensure consistent deployment, reliable communication, and simplified system support. By default, AMP uses the IP subnet 172.27.0.0/16 (255.255.0.0) for the Device Network. This prefix is auto…
30-Jun-2026
CLI Commands for Omega & Ultra Series Devices
Overview Omega and Ultra Series devices use the same firmware and operating system. Commands on Just Add Power alter the live behavior of the device. Commands will execute immediately, but may not persist through reboot. Requires devices to be on justOS firmware version B1.0.0 or later. For Settings that alter …
05-Jun-2026
Startup Settings for Omega & Ultra Series Devices
Overview Startup settings determine how an Omega Series or Ultra Series device behaves after it boots. They are stored in non-volatile memory and remain active after the device is power cycled. Most startup settings are configured through the Command Line Interface (CLI) using the astparam utility. This article…
02-Sep-2026
