Overview
AMP - Advanced Matrix Programmer - configures Omega, Ultra, or MaxColor devices into an HDMI matrix switching system.
AMP is the spiritual successor to JADConfig. If you were previously using JADConfig to configure Omega and Ultra systems, you can continue to use it for maintaining those systems. However, we recommend that NEW systems should be configured with AMP.
There are two types of systems that can be configured by AMP:
- Standardized Configuration
- AMP configures all Omega, Ultra, and MaxColor Series Just Add Power Encoders & Decoders AND the switch.
- Uses supported switches from this list.
- Select Build & Expand to get started.
- Builds systems with up to 63 switches, 101 Encoders, and 3023 Decoders
- Alternate Configuration
- AMP configures all Omega, Ultra, and MaxColor Series Just Add Power Encoders & Decoders. YOU are responsible for configuring the switch.
- The switch must be configured according to minimum requirements.
- Select Alternate Configuration from the bottom-left corner to get started.
- Builds systems with up to 9,999 Encoders and theoretically unlimited Decoders (based on network design).
Standardized Configuration is preferred. It essentially converts the switch into a video matrix switcher, with the added benefit of being able to use extra ports for data devices.
See Standard vs Alternate Configuration to determine which type of system is best for the job site.
Begin planning a MaxColor system here.
Begin planning an Ultra system here.
Compare MaxColor and Ultra here.
Download
Version Information
Current version: v1.3.3
Release Date: 2025-03-31
Standardized Configuration Supported Switches
In Standardized Configuration, the program configures the switch and all Just Add Power devices for you! AMP VLAN supports up to 63 switches in a system.
Standardized Configuration Supported Switch List
Alternate Configuration Switch Requirements
In Alternate Configuration, the switch must meet minimum requirements. You are responsible for configuring the switch; Just Add Power provides example profiles, but AMP does NOT configure the switch.
Just Add Power Firmware
Omega: B3.0.3
Ultra: B3.0.3
MaxColor: MAX v4.3.2
Changelog
Added
Fixed
Changed
- MaxColor Series firmware is MAX v4.3.2
- Default username/password for Luxul switches is now admin/Admin1234!
Known Issues
[version] Issue
- [1.3.3] Report files for Luxul systems are still reporting the password admin, even though the actual password is Admin1234! for systems setup with v1.3.3
- [1.0.0] WILL NOT auto-update to future versions. If you have v1.0.0, please download and install the latest version and it will auto-update going forward
