[Netgear] Static ARP Table Entry
Overview Some models of Netgear M4250 and M4350 switches supported by Just Add Power are having an issue where they do not register the MAC address of connected devices automatically - leaving the ARP table blank. This results in devices not being accessible over the network - webUI, telnet, and ping all fail. We a…
27-Nov-2024
[Netgear M4250] Download Switch Configuration via AV webUI
* Overview * Walkthrough Overview Downloading a switch configuration file might be done for any of these reasons: * Having a backup copy of the switch configuration in case of failure * Copying the configuration from one switch to another Walkthrough * Login to the switch webUI through the AV UI Login * Go t…
21-Jun-2023
[Netgear M4250] Download Switch Configuration via Main webUI
* Overview * Walkthrough Overview Downloading a switch configuration file might be done for any of these reasons: * Having a backup copy of the switch configuration in case of failure * Copying the configuration from one switch to another Walkthrough * Login to the switch webUI and select the Main UI Login …
21-Jun-2023
Upload Switch Config to Netgear M4250 Series Through Main UI Login
* Overview * Minimum Switch Firmware * Walkthrough Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Final Configuration file These instructions will fit any of t…
19-Oct-2023
Upload Switch Config to Netgear M4250 Series Through AV UI Login
Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Discovery Configuration file These instructions will fit any of these situations. Important Note: At this time, S…
27-Aug-2024
[AMP] [Standardized] Multi-Switch Considerations
Overview If the Right Switch for a Standardized System (also known as a VLAN Switching System) requires more than one switch, AMP supports up to 63 switches in a single system. Those switches need additional considerations: * All switches in the system must be from the SAME MANUFACTURER , but may be differen…
18-Dec-2024
[AMP] [Standardized] Choosing the Right Switch
Overview Building a Standardized Configuration in AMP will fully configure the switches listed below and make them compatible with Just Add Power-provided drivers to support them. When planning a Standardized System (also known as a VLAN Switching System), one of the most important decisions is the managed gigabi…
18-Dec-2024
