Overview Some models of Netgear M4250 and M4350 switches supported by Just Add Power are having an issue where they do not register the MAC address of connected devices automatically - leaving the ARP table blank. This results in devices not being accessible over the network - webUI, telnet, and ping all fail. We a…
* Overview * Minimum Switch Firmware * Walkthrough Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running Standardized AMP and loading the Discovery Configuration file These instructions …
* Overview * Walkthrough Overview Downloading a switch configuration file might be done for any of these reasons: * Having a backup copy of the switch configuration in case of failure * Copying the configuration from one switch to another Walkthrough * Login to the switch webUI through the AV UI Login * Go t…
* Overview * Minimum Switch Firmware * Walkthrough Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running Standardized AMP and loading the Discovery Configuration file These instructions …
* Overview * Walkthrough Overview Downloading a switch configuration file might be done for any of these reasons: * Having a backup copy of the switch configuration in case of failure * Copying the configuration from one switch to another Walkthrough * Login to the switch webUI and select the Main UI Login …
* Overview * Minimum Switch Firmware * Walkthrough Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Final Configuration file These instructions will fit any of t…
Overview Just Add Power always recommends AMP Standardized systems (VLAN switching) over multicast switching. Netgear switches are supported with Standardized AMP and should allow AMP to configure the switch whenever possible. This article is intended for situations where VLAN switching is not feasible for the pr…
Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Discovery Configuration file These instructions will fit any of these situations. Important Note: At this time, S…
Overview If the Right Switch for a Standardized System (also known as a VLAN Switching System) requires more than one switch, AMP supports up to 63 switches in a single system. Those switches need additional considerations: * All switches in the system must be from the SAME MANUFACTURER , but may be differen…
Overview Building a Standardized Configuration in AMP will fully configure the switches listed below and make them compatible with Just Add Power-provided drivers to support them. When planning a Standardized System (also known as a VLAN Switching System), one of the most important decisions is the managed gigabi…