3G Ultra Receivers on the Same Switch Port
VLAN Switching In a VLAN Switching system, the A/V signal is switchport-based. This means that all Receivers connected to the same switch port will always show the same Transmitter. It also means that a port only has the bandwidth of a single A/V signal so the full 1Gbps of the network wire is available to it. No …
14-Apr-2022
Upload Switch Config to TP-Link TL-SG34XX Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Discovery Configuration file These instructions will fit any of these situations. Minimum Switch Firmware TP-Link…
07-Nov-2024
Upload Switch Config to Cisco CBS350 Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Running AMP and loading the Discovery Configuration file * Copying the configuration from a defective switch into the replacement switch These instructions will fit any of these situations. Minimum Switch Firmware Cisco C…
19-Nov-2024
Instructions - SwitchPlease Matrix Web Control for JADConfig Systems
Overview SwitchPlease is a web interface running on a single Decoder that provides full HDMI switching control for the Just Add Power HD over IP solution. No control system needed! SwitchPlease is included in the core firmware starting at A6.5.5 and B1.0.0 Requirements * IP address of Just Add Power setup and in…
12-May-2025
Choosing the Right Switch for AMP Standardized Systems
Overview Building a Standardized Configuration in AMP will fully configure the switches listed below and make them compatible with Just Add Power-provided drivers to support them. When planning a Standardized System (also known as a VLAN Switching System), one of the most important decisions is the managed gigabi…
29-May-2025
