[AMP] [Standardized] JADConfig Stack Conversion
Overview Advanced Matrix Programmer provides a path forward for all legacy installations configured using JADConfig in a stacked topology using two or more switches. This article covers the steps required to migrate from Stacking to Trunking, combining or replacing any existing legacy multi-switch models at the job…
24-Jun-2024
Upload Switch Config to Luxul SW-510 and -610 Series
Overview Uploading a switch configuration file might be done for any of these reasons: * Copying the configuration from a defective switch into the replacement switch * Running AMP and loading the Discovery Configuration file These instructions will fit any of these situations. Minimum Switch Firmware Luxul S…
15-Oct-2024
[AMP] [Standardized] Multi-Switch Considerations
Overview If the Right Switch for a Standardized System (also known as a VLAN Switching System) requires more than one switch, AMP supports up to 63 switches in a single system. Those switches need additional considerations: * All switches in the system must be from the SAME MANUFACTURER , but may be differen…
18-Dec-2024
[AMP] [Standardized] Choosing the Right Switch
Overview Building a Standardized Configuration in AMP will fully configure the switches listed below and make them compatible with Just Add Power-provided drivers to support them. When planning a Standardized System (also known as a VLAN Switching System), one of the most important decisions is the managed gigabi…
18-Dec-2024
