[MaxColor] Serial over IP
* Overview * Direct (TCP:6752) * Passive (Point-to-Point) * API (CLI Access) Overview Just Add Power supports 3 Types of serial management of endpoint devices: * Direct: Commands enter the system via an IP telnet connection to port 6752 of a Transmitter or Receiver. The command passes out of the RS232 port. 2-…
31-Jul-2023
[MaxColor] HDMI Cable Requirements
Overview MaxColor supports high-quality video sources at 4K60, 4:4:4 color space, 36-bit color depth. The HDMI cable must also be able to support these requirements. Just Add Power MaxColor devices require HDMI cables that are: * Passive * Premium High Speed or Ultra High Speed Definitions A Passive HDMI cabl…
26-Jun-2024
How To: MaxColor IR Control
Overview MaxColor Transmitters and Receivers have a native IR output. The IR output is always enabled. Requirements MaxColor devices must be on firmware MAX V3.7.1 or later Early productions of MaxColor - QC sticker May 2022 or earlier - have a hardware limitation that prevents IR from working. Please reach ou…
11-Nov-2024
MC-TX2 Spec Sheet: MaxColor Series 2 Transmitter
Model Number MC-TX2 Go to Product Page Compatibility All MaxColor devices are compatible with each other. For information on how to bridge MaxColor devices with an existing 3G Ultra system, please see this article .
22-Feb-2024
[MaxColor] Receiver Scaler Settings
Overview All MaxColor Receivers have a built-in video scaler. This enables a source to be set to the maximum resolution even when all displays may not support that resolution. The Receiver will adjust the output resolution so that the display can properly play the video. Standard Resolutions MaxColor Receivers com…
26-Jun-2024
[MaxColor] Audio Return Channel (ARC) Pass-through with MaxColor Series 2 Transmitters and Receivers
Overview The MaxColor Series 2 Transmitter and Series 2 Receiver - MC-TX2 and MC-RX2 - add support for Audio Return Channel (ARC) when used in a point-to-point connection between a display and AVR that both support ARC. MaxColor Series 2 devices support ARC. They do NOT support eARC. MaxColor Series 2 devices do N…
24-Jun-2024
[MaxColor] Latency Information
The encode/decode process performed by Just Add Power converts HDMI into network packets on the Transmitter side and converts the network packets back into HDMI on the Receiver side. This process introduces a minor delay. MaxColor latency is 16 milliseconds - Equivalent to less than one frame of 60Hz content.
26-Jun-2024
[MaxColor] Factory Default a Device
Overview There are three ways to Factory Default a unit: * Via the webUI * Via telnet * Via a Debug Cable Just Add Power Factory Default IP Settings are: * IP Mode: Auto IP * IP Address: 169.254.x.x /16 * Default Gateway: None Other Factory Default settings vary based on the model and the firmware version. …
09-Jul-2024
MC-RX1 Spec Sheet: MaxColor Series 1 Receiver
Model Number MC-RX1 Go to Product Page Compatibility All MaxColor devices are compatible with each other. For information on how to bridge MaxColor devices with an existing 3G Ultra system, please see this article .
22-Feb-2024
MaxColor Project Planning Guide
* Introduction * Part 1: Choose Receivers & Transmitters * Part 2: Consider Accessory Parts * Part 3: Choose a System * Part 4: Control System & Drivers * Contact for Planning Assistance Introduction The Just Add Power MaxColor system is a 4K60 , 36-bit color , 4:4:4 color format HDMI over IP distribution …
23-Feb-2024
