[3G Ultra] [Wallplate] Settings and Commands
Overview Two types of Wallplate Transmitters are available: * VBS-HDIP-717WP2: 2-gang, HDMI and VGA in, Line-In, Micro USB, Source Dipswitch, POE network * VBS-HDIP-718WP4: 4-gang, HDMI and VGA in, Line-In, Micro USB, Source Dipswitch, POE network, Mic-In, HDMI out, Stereo out, RS232 with null modem Settings are …
25-Jun-2024
Set Web Name
Devices on firmware A5.21d and later have the ability to apply a name to the web interface to distinguish it from other Just Add Power devices in a system. Setup * Log into the web interface of the device and go to the System --> Utilities bar * Alternatively, telnet into the device * Apply the command below, …
26-Apr-2018
[2G Hybrid] Device Settings
Overview Settings on Just Add Power alter the behavior of the device upon start-up. Settings that are changed will not be active immediately; they will be applied upon the next start-up. Many settings should be altered according to the unique situation present in each installation and are not recommended as blanket …
10-Jul-2024
[2G Hybrid] Device Management
The PDF attached to this Knowledge Base article provides information on the web interface of Just Add Power 2G devices. Many features of the Just Add Power 2G system can be configured from the web interface: * Check Firmware * Change IP Address * Reboot * Factory Default * Change EDID * USB * RS232
10-Jul-2024
[3G Ultra] Device Settings
Overview The 3G System includes all 2GΩ/3G and 3G devices. Essentially, any device in a black metal casing. Settings on Just Add Power alter the behavior of the device upon start-up. Settings that are changed will not be active immediately; they will be applied upon the next start-up. Many settings should be altere…
03-Sep-2024
