⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️
2G Legacy Mode Firmware: L1.1.9.0
Overview Firmware L1.1.9.0 enables 2G Series devices and compatible Omega Series and Ultra Series devices to operate under the JPSW switching structure used by AMP 2G Legacy Mode. This is the first L Series firmware release and requires AMP 2.0.0 or later . L Series firmware is intended only for AMP 2G Legac…
02-Oct-2026
Understand 2G Legacy Mode Compatibility
Overview 2G Legacy Mode allows compatible Omega Series and Ultra Series devices to operate with 2G Series Encoders and Decoders. AMP 2.0.0 or later supports these systems through its normal discovery, configuration, and firmware update workflows. On compatible Omega Series and Ultra Series devices, 2G Legacy Mode…
02-Oct-2026
Troubleshoot a 2G Legacy Mode System (2G Legacy Mode)
Overview Use this guide to troubleshoot video, startup, and network connection problems in an established Just Add Power 2G Legacy Mode system. It applies to 2G Series Encoders and Decoders and to compatible Omega Series or Ultra Series devices operating in 2G Mode. Start by identifying whether the problem affects …
01-Oct-2026
Understand Power and Data LED Behavior (Omega, Ultra, and MaxColor Series)
Overview Just Add Power devices have a green Power LED and Data LED that can help narrow down startup, network, and video problems. On rackmount devices, use the LEDs on the port side for these checks. This article covers common LED behavior on Omega Series, Ultra Series, and MaxColor Series Encoders and Decoders. …
30-Sep-2026
Replacement Models for 2G Series Devices
Overview Just Add Power 2G Series devices, including 2G+ models, are no longer in production. The compatible Omega Series and Ultra Series models listed below provide replacement options for existing installations. When operating in 2G Legacy Mode , replacement devices function within the capabilities of the 2G Se…
02-Oct-2026
How to Control the Power & Data LED of a Device (2G Series and 2G Legacy Mode)
Overview Starting with firmware version A6.5.5 , 2G Series Just Add Power Encoders and Decoders support disabling the Power and Data LED indicators. This feature is useful in environments where visible LEDs are undesirable, such as theaters, conference rooms, or other light-controlled spaces. LED control is…
02-Oct-2026
How to Name a Device (2G Series and 2G Legacy Mode)
Overview Devices running 2G Series firmware A5.21d or later can be assigned a custom webname. The webname appears in the device webUI and helps identify individual Encoders and Decoders within a system. Set the Device Name * Access the device CLI using one of the following methods: Open the device webUI a…
02-Oct-2026
How to Update Firmware (2G Series and 2G Legacy Mode)
Overview The firmware update method depends on how the system is configured: * AMP 2G Legacy Mode: Use AMP 2.0.0 or later to apply L Series firmware through its configuration workflow. * Established A Series systems: Use the A Series maintenance instructions below when the system is remaining on A Series firm…
02-Oct-2026
Choosing between Standardized and Alternate Configurations
Overview Advanced Matrix Programmer (AMP) offers two configuration methods for Just Add Power systems: Standardized Configuration and Alternate Configuration . Both configure Encoders and Decoders, but they differ in how sources are switched and who configures the network. Standardized Configuration is recommend…
02-Oct-2026
How to Identify the Model Number of a Device (2G Series and 2G Legacy Mode)
Overview There are many ways to identify the model/SKU number of a Just Add Power transmitter or receiver. These instructions will cover two ways to find this information: * Command Line Interface [CLI] * Physical Identification Command Line Interface [CLI] This function is only supported on Firmware A6.4.12 a…
02-Oct-2026
