[3G Ultra] [Wallplate] Input Video Selection Management
Wall-plate transmitters allow users to chose between VGA and HDMI distribution. There are three ways to chose how formats are toggled between. 1) Use the physical toggle button to switch between VGA and HDMI (factory default setting): astparam s v_input_select auto;astparam save;reboot 2) Detect a change in video …
25-Jun-2024
[3G Ultra] [Wallplate] Settings and Commands
Overview Two types of Wallplate Transmitters are available: * VBS-HDIP-717WP2: 2-gang, HDMI and VGA in, Line-In, Micro USB, Source Dipswitch, POE network * VBS-HDIP-718WP4: 4-gang, HDMI and VGA in, Line-In, Micro USB, Source Dipswitch, POE network, Mic-In, HDMI out, Stereo out, RS232 with null modem Settings are …
25-Jun-2024
CLI Settings for 2G Series Devices
Overview Settings on Just Add Power alter the behavior of the device upon start-up. Settings that are changed will not be active immediately; they will be applied upon the next start-up. Many settings should be altered according to the unique situation present in each installation and are not recommended as blanke…
23-Jun-2025
Multicast Switching Protocol
* Overview * Requirements * Concepts Default Multicast IPs Multicast IP to Channel Translation * Basic Mode Commands Set Basic Mode Set Audio & Video Channel Set Management IP * Advanced Mode Commands Set Advanced Mode Set Audio Channel Set Video Channel Set USB Channel Set Management I…
01-Dec-2023
CLI Settings for Omega & Ultra Series Devices
Overview Omega & Ultra Series devices use the same firmware and operating system. Settings on Just Add Power alter the behavior of the device upon start-up. Settings that are changed will not be active immediately; they will be applied upon the next start-up. Many settings should be altered according to the uniqu…
23-Jun-2025
