⚠️ JADConfig will reach End of Support on January 1, 2027. View the official notice! ⚠️

Showing articles from Settings tag

Switch Configuration Guidelines for AMP Standardized Systems

Overview AMP Standardized systems provide a switch configuration built specifically for the size of the Just Add Power system. Ports are distributed in a controlled way so that systems can be inventoried with a minimal amount of information. This article covers the standards applied to the switch configuration. Use…

Section: AMP Documentation

Last Updated at
16-Sep-2025

Tags: AMP Advanced Matrix Programmer VLAN Standardized Switch Configure Settings Switch Settings Modifiable Unmodifiable
How to Set Startup Settings (2G Series and 2G Legacy Mode)

Overview Startup settings on a Just Add Power device define how the unit behaves when it powers on. Any changes made to these settings are not applied immediately and will only take effect after the device is rebooted. Many settings are intended for specific installation scenarios and should not be applied as g…

Section: 2G Legacy Mode

Last Updated at
02-Oct-2026

Tags: 2G astparam Device Management CLI Command Line Settings Parameters Advanced 2G Legacy Mode